Arming The Starter Kill; Remote Starting Your Vehicle; Setting Your Vehicle Into Ready Mode - Autostart AS-2272 User Manual

Arming the Starter Kill

Note: It can only be activated if button Ι is programmed as
The Starter Kill (if installed) can be configured by the installer either to Passive Mode (so as to arm
automatically) or Active Mode (so as to require the user's intervention for arming). By default, your
Remote Car Starter is configured to Passive Mode.
Passive mode:
• To arm the Starter Kill, press the Ι button on the transmitter, OR
• In Passive Mode, the Starter Kill will also automatically arm 1 minute (by default) or 3 minutes (if
configured this way) after the ignition is turned
monitored).
- The LED on the antenna will flash quickly during the countdown preceding the activation
of the Starter Kill.
- Once the activation countdown expires, the LED will send a series of quick double
flashes to indicate that the Starter Kill is now armed.
• To disarm the Starter Kill, press the Ι button on the transmitter.
- The Starter Kill will automatically rearm itself after 1 minute (by default) or 3 minutes (if
configured this way) if no door is left opened (if the doors are monitored) and the ignition
is not turned
ON
Active Mode:
• To arm the Starter Kill, press the Ι button on the transmitter.
- The parking lights will flash once.
- The LED on the antenna will flash slowly.
- If remote door locks are installed, this will also lock the doors.
• To disarm the Starter Kill, press the Ι button on the transmitter.
- The parking lights will flash twice.
- The LED on the antenna will remain
- If remote door locks are installed, this will also unlock the doors.

Remote Starting Your Vehicle

If your vehicle has an automatic transmission, simply press the ΙΙ button to remote start or the
Ι button to stop your vehicle. Skip the next steps on to "Remote-starting".

Setting Your Vehicle Into Ready Mode

If your vehicle has a manual transmission you must read the following indications. In order to start the
vehicle by remote, the unit must first be set to Ready Mode. If the unit is not set to Ready Mode, it
cannot remote start the vehicle.
Please note that Ready Mode can be enabled by the remote or the handbrake, depending on the
option that was selected by your installer. Therefore, you must follow the appropriate procedure
between the two described below in order to set your vehicle into Ready Mode.
Once the system is set to Ready Mode, the vehicle can be remote started and stopped at any time. The
system will exit Ready Mode if a door, the hood or the trunk is opened, if the brake pedal is pressed, if
the parking brake is disengaged or if the ignition key is turned to the
User Guide
.
LOCK
or once the last door is closed (if the doors are
OFF
.
OUT
or button.
UNLOCK
position.
IGNITION ON (RUN)
P. 3