Honeywell YRTH7500D1009 - 5 Day Program Thermostat Quick Start Manual

Installation is Easy
Label wires and remove your old thermostat
Install and wire your new thermostat
Set your new thermostat to match your heating/cooling
system
– This thermostat works with virtually all System
Types
– It is preset for the most common system
This thermostat works on 24 volt or 750 mV systems. It will
NOT work on 120/240 Volt systems.
5 6
Mount Wallplate
Mount the new wallplate using the included screws Simply match wire labels.
and anchors.
CONVENTIONAL
C
G
Y
W
RC
R
Remove metal jumper if you have both R and Rc wires.
MCR28094
Drill 3/32-in. holes for plaster
Drill 3/16-in. holes for drywall Labels don't match?
Have a Heat Pump system?
Call 1-800-468-1502 for wiring assistance.
Turn OFF
1
Cooling System
We are here to help.
2
Remove Old Thermostat
Call 1-800-468-1502 for
wiring assistance before
returning the thermostat to
the store. Remove old thermostat but leave wallplate with
wires attached.
Leave wallplate in
place
Old thermostat
7
Connect Wires Install Batteries
Install two AA alkaline batteries and remove tab.
SCREW
INSERT WIRES
THEN TIGHTEN SCREWS
LABELED WIRES
WIRE HOLE
W2
Y2
Back of thermostat
MCR28070
See Wiring Notes (over).
See Wiring Notes (over).
Remove tab.
Power to Heating/
3
Label Wires with Tags
Label the wires using the supplied wire labels as you
disconnect them, then remove the old wallplate.
or
Is there a sealed tube containing Wire color might not match labels.
mercury? If so, see back cover for
proper disposal instructions.
Wire Labels
EM. HEAT AUX. HEAT
50 60 70 80
50 60 70 80 F
EM. HEAT AUTO OFF
MCR33835
Cover NOTE: Jumper wire used on old thermostat? If yes, note
what letters the jumper connected and review in wiring
section.
8
Install Thermostat onto Wallplate
Install thermostat onto the wallplate on the wall.
MCR28101
9
Turn Power Back
Turn the power back on to the heating/cooling system.
MCR27518
Separate Wallplate from
4
New Thermostat
Remove wallplate from the new thermostat.
M31545
Wallplate
MCR33763
10
Set Time and Date
Press or to set month, then press NEXT.
s t
Press s or t to set day, then press NEXT.
Press s or t to set year, then press DONE.
Month Year Day
6
15
2012
Go Back Next Done
M27519
MCR33842
Press or to set time, then press DONE to save and
s t
ON
exit.
10:10
Done
or
MCR33843
This thermostat contains a Lithium battery which
may contain Perchlorate material.
Perchlorate Material—special handling may apply,
See www.dtsc.ca.gov/hazardouswaste/perchlorate
MERCURY NOTICE: Do not place your old
thermostat in the trash if it contains mercury in a
sealed tube. Contact the Thermostat Recycling
Corporation at www.thermostat-recycle.org or 800-
238-8192 for information on how and where to
properly and safely dispose of your old thermostat.
CAUTION: To avoid possible compressor damage,
do not run air conditioner if the outside temperature
drops below 50°F (10°C).
Automation and Control Solutions
Honeywell International Inc.
1985 Douglas Drive North
Golden Valley, MN 55422
M28073
http://yourhome.honeywell.com
® U.S. Registered Trademark.
© 2012 Honeywell International Inc.
69-2722—01 M.S. 05-12
Printed in U.S.A.
11
If your system type is...
If your system type is:
q Single Stage Heat and Cool
Congratulations, you're done!
Thermostat is set with energy saving schedule; see operating
manual to adjust schedule.
If your system type is:
q Multistage Heat and Cool
q Heat Pump* without Backup Heat
q Heat Pump* with Backup Heat
q Heat Only
q Cool Only
Continue to step 12a to match your thermostat to your
system type.
*Heat Pump—an air conditioner that provides cooling in the
summer, and also runs in reverse in the winter to provide
heating.
If you are not sure of your system type or if you have
other questions, call us toll-free at 1-800-468-1502.