Sony Ipela SNC-RS86N User Manual page 97

Adding an inactive area
Clicking Adding an inactive area will add an
inactive area window in the center of the screen.
When you place the cursor on the area, the cursor
changes to a crossed arrow, which you can drag to
move the area.
When you place the cursor on the vertex of the area,
the cursor changes to n, which you can drag to
move the vertex.
Deleting a region
Clicking this button will change the cursor to a
button. While the cursor is a button, click on a part
of the area to delete that area.
After the deletion, the cursor will return to its
original form. To exit this operation, click this
button again.
It is the same function as the button displayed under
VMF settings.
Adding a vertex
Clicking Adding a vertex will change the cursor to
a button. In that state, when you click on a part of
the side of the area, a vertex is added to that point.
After the addition, the cursor will return its original
form. To exit this operation, click this button again.
It is the same function as the button displayed in
VMF settings.
Deleting a vertex
Clicking Deleting a vertex will change the cursor
to a button. In that state, when you click on a part of
the vertex of the area, the vertex added to that point
is deleted. After the deletion, the cursor will return
its original form. To exit this operation, click this
button again.
It is the same function as the button displayed in
VMF settings.
Note
The vertex can be moved in an outward direction
but cannot be moved toward the inside of an area.
Detection sensitivity
Set the sensitivity of motion detection.
A value from 1 to 100 can be specified.
The values of the slide bar and spin button are
synchronized.
Setting the Sensor input/Camera tampering detection/Motion detection/Audio detection — Event detection menu
Clicking Return to the default changes the value to the
default value.
Detection response
Set the response velocity of motion detection.
A value from 1 to 5 can be specified.
Clicking Return to the default changes the value to the
default value.
Detection size
Specify the minimum detection size and maximum
detection size of motion detection. To specify the
detection size, you can either enter values or drag the
vertexes of the area.
The area size is measured in pixels.
• When you place the cursor on the area, the cursor
changes to a crossed arrow, which you can drag to
move to the minimum detection size area and
maximum detection size area.
• When you place the cursor on the vertex of the area,
the cursor changes to n. Drag and move the vertex
to adjust the detection size.
Moving shadow exemption
Set ON/OFF for the moving shadow exemption function
of motion detection.
Selecting ON will prevent the shadows of a moving
object from being recognized as moving objects.
Remove the check to disable the shadow removal
function of motion detection.
97