GE JS750SFSS Dimensions And Installation Information

JS750SF
GE 30" Slide-In Electric Convection Range
®
Dimensions and Installation Information (in inches)
Receptacle Locations: Locally approved flexible service cord or conduit must
be used because terminals are not accessible after range installation. See
shaded area in drawing for location of electrical outlet box. Recommended
outlet locations allow range to be installed directly against rear wall.
Note: This appliance has been approved for 0" spacing to adjacent
surfaces above the cooktop. However, a 6" minimum spacing to surfaces
less than 15" above the cooktop and adjacent cabinet is recommended
to reduce exposure to steam, grease splatter and heat.
Installation Information: Before installing, consult installation insgtructions
for current dimensional data and additional requirements
Optional Kits For Slide-In
Electric Ranges
(Available At Additional Cost)
Shave Raised Edge To Clear
31-1/8" Wide Control Panel
Accessory Backguards
30 " Mi n.
Excluding Model JSS28
(Attaches to the back of range
as a backguard when unit is
9/16
installed in 30" free-standing
cutout)
JXS32SS (Stainless) - 4" High
30 " Mi n.
JXS32BB (Black) - 4" High
Acceptable
Optional Lower Trim Kits
Electrical
(If counter height is greater
Outlet Area
15" Min.
than 36.5", a lower trim kit
is recommended to extend
the useful height to 38"
If you are NOT using the
25
maximum)
Filler strip or Backguard:
JXS56BB – Black
KW Rating
240V
13.5
7-1/2
208V 10.1
Breaker Size
240V 40 Amps 2-1/2
†
208V 40 Amps
†
15" Min.
Note: Check local codes for required breaker size.
†
If you are using the
Filler strip or Backguard:
24
Body Sides
(Slide-in ranges are sold
without sides installed. Can If you are NOT using the
be installed on either left Filler strip or Backguard:
or right when unit has one
exposed side [no cabinet
adjacent]. Kit contains
1 body side)
JXS77BB (Black)
Rear Filler Strip
WB07T10680 - Black Filler Strip Assembly
If you are using the
Filler strip or Backguard:
23-3/16
30
Accessory
Backguard JXS32
For answers to your Monogram
appliance questions, visit our website at
geappliances.com or call GE Answer Center
service, 800.626.2000.
4
25
31-1/4
30 " Mi n.
Recommended
6" Min.
From Walls
30 " Mi n.
23-3/16
35-7/8"–38"
from floor to
countertop
2-1/2
30
23-3/16
2-7/8"
To Front
30 Surface Of
Countertop
25
30
or GE
® ®
If the countertop area is not at, excess tension may be applied to the glass cooktop, causing breakage and
voiding the warranty. Make sure the wall covering, countertop, ooring and cabinets around the range can
withstand the heat (up to 200°F) generated by the range.
®
A. Allow 30" minimum clearance between surface units and bottom of unprotected wood or metal cabinet, or
allow a 24" minimum when bottom of wood or metal cabinet is protected by no less than 1/4"-thick
ame-retardant millboard covered with no less than No. 28 MSG sheet metal (.015" thick), .015"-thick stainless
steel, .025" aluminum or .020" copper.
B. This appliance has been approved for 0" spacing to adjacent surfaces above the cooktop.
However, a minimum 6" spacing to surfaces less than 15" above the cooktop and adjacent cabinetry
is recommended to reduce exposure to steam, grease splatter and heat. Allow 1/4" minimum
Shave Raised Edge To Clear
31-1/8" Wide Control Panel
Recommended
Excluding Model JSS28
6" Min.
From Walls
9/16
Acceptable
23-3/16
Electrical
Outlet Area
15" Min.
25
35-7/8"–38"
from floor to
countertop
2-1/2
7-1/2
2-1/2
30
24
31-1/4
2-7/8"
To Front
Surface Of
Countertop
36-1/4
20-5/8" Door
Clearance
From Front
Surface of
Countertop
25-3/4*
(excluding handle)
ADA qualified based
*
All GE ranges are equipped with
on Uniform Federal
an Anti-Tip device. The installation
Accessibility Standards of this device is an important,
required step in the installation
of the range.
Specification Created 5/13
Shave Raised Edge To Clear
31-1/8" Wide Control Panel
If you are NOT using the
30 " Mi n.
Excluding Model JSS28
Filler strip or Backguard:
9/16
23-3/16
30 " Mi n.
Acceptable
30
Electrical
Outlet Area
15" Min.
If you are using the
25
Filler strip or Backguard:
25
7-1/2
30
2-1/2
Accessory
Backguard JXS32
4
24
31-1/4
20-5/8" Door
Clearance
From Front
Surface of
Countertop
*Total depth from wall to
front of closed oven door
including handle is 28-1/2.
(excluding handle
Listed by
Underwriters
Laboratories
320637
If the countertop area is not at, excess tension may be applied to the glass c
voiding the warranty. Make sure the wall covering, countertop, ooring and
withstand the heat (up to 200°F) generated by the range.
25-3/4*