Table of Contents
Advertisement
11) SATA0/1 (SATA 6Gb/s Connectors)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s standard.
Each SATA connector supports a single SATA device.
• A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard drives
are configured, the total number of hard drives must be an even number.
• A RAID 10 configuration requires four hard drives.
(Note)
When a RAID configuration is built across the SATA 3Gb/s channels, the system performance of
the RAID configuration may vary depends on the devices are connected.
12) F_USB1 (USB Headers)
The headers conform to USB 2.0/1.1 specification. Each USB header can provide two USB ports via an
optional USB bracket. For purchasing the optional USB bracket, please contact the local dealer.
7
1
1 2
9 10
- 21 -
When SATA_DOM0/1 jumper
are set to Normal Mode:
Pin No.
Definition
1
GND
2
TXP
3
TXN
4
GND
5
RXN
6
RXP
7
GND
When SATA_DOM0/1 Jumper
are set to 1-2 pin:
Pin No.
Definition
1
GND
2
TXP
3
TXN
4
GND
5
RXN
6
RXP
7
P5V
Pin No.
Definition
1
Power (5V)
2
Power (5V)
3
USB DX-
4
USB DY-
5
USB DX+
6
USB DY+
7
GND
8
GND
9
No Pin
10
NC
Hardware Installation
Advertisement
Table of Contents
