6
Click [Yes] when the message is displayed indicating that the
network connection will be temporarily interrupted.
• When you create Generic Trunking and Link Aggregation teams, you cannot designate a
standby member.
Standby members work only with Smart Load Balancing and Failover and SLB (Auto-
Fallback Disable) types of teams.
• For an SLB (Auto-Fallback Disable) team, to restore traffic to the load balance members
from the standby member, click the Fallback button on the "Team Properties" tab.
7
Configure the team IP address.
1. Click "Control Panel" → "Network Connections".
2. Right-click the name of the team to be configured, and then click "Properties".
3. On the "General" tab, click "Internet Protocol (TCP/IP)", and then click
"Properties".
4. Configure the IP address and any other necessary TCP/IP configuration for the
team, and then click [OK] when finished.
Modifying a Team
After you have created a team, you can modify the team in the following ways:
• Change the type of team
• Change the members assigned to the team
• Add a VLAN
• Modify a VLAN (using Expert Mode)
• Remove a team or a VLAN (using Expert Mode)
188
The team name cannot exceed 39 characters, cannot begin with spaces, and
cannot contain any of the following characters: & \ / : * ? < > |
Team names must be unique. If you attempt to use a team name more than once,
an error message is displayed indicating that the name already exists.
The maximum number of team members is 8.
When team configuration has been correctly performed, a virtual team adapter
driver is created for each configured team.