Entering The Service Tag In The Bios - Dell i1470-2932CRD - Inspiron 1470 Cherry Service Manual

10. Replace the coin-cell battery (see
11. Replace the Mini-Card (see
12. Connect the USB/audio cable under the module cover that is connected to the system board and USB/audio board.
13. Replace the memory module(s) (see
14. Replace the module cover (see
15. Replace the optical drive (see
16. Replace the battery (see Replacing the
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
17. Turn on the computer.
NOTE: After you have replaced the system board, enter the computer's Service Tag into the BIOS of the replacement system board.
18. Enter the service tag (see Entering the Service Tag in the
Entering the Service Tag in the BIOS
1. Ensure that the AC adapter is plugged in and that the main battery is installed properly.
2. Turn on the computer.
3. Press <F2> during POST to enter the system setup program.
4. Navigate to the security tab and enter the service tag in the Set Service Tag field.
Back to Contents Page
Replacing the Coin-Cell Battery).
Replacing the Mini-Card).
Replacing the Memory Module(s)).
Replacing the Module Cover).
Replacing the Optical Drive).
Battery).
BIOS).