Tv Menu-Install - Haier L42S9 Owner's Manual

TV menu-Install

Main Control
Install 5
Language
Auto store
Manual store
Channel setting
Factory reset
Select
Enter
Main Control
Install 5
Language
Auto store
Manual store
Channel setting
Factory reset
Select
Enter
Auto store
Please wait
Prog. found
Frequency 4
Notes:
• Immediately after unpacking and plugging in your new television, run the Auto store function to set up the TV for the
broadcast or cable channels available in your area. If you do not run the Auto store function to set up the channels, your
television may not operate properly.
• After you've run Auto store, check out the results. Press CH
• Remember, an antenna or cable TV signal must first be connected to your LCD TV.
Language
2
English
Exit
Auto store
Start ?
Exit
0
9 .25 MHz
Select the menu language
Press the MENU button on the remote control.
2
Use the cursor down to select Install in the Settings menu.
3
Use the cursor right to enter the Install menu.
4
Select Language and enter the list of available languages
with the cursor right.
5
Select your preferred language with the cursor up/down and
press the OK button to confirm your selection.
6
Proceed with the Install menu.
Store TV channels
Press the MENU button on the remote control.
2
Use the cursor down to select Install in the Settings menu.
3
Use the cursor right to enter the Install menu.
4
Press cursor down to select Auto store in the Install menu.
5
Use the cursor right to enter the Auto store menu and press
OK to start channel scanning.
Auto storing may take up to 3 minutes to complete. Please
wait until Auto storing is completed . The TV will then switch
automatically to the first channel found.
or the CH button and see which channels you can select.
15