NETGEAR WNDAP330 - ProSafe - Wireless Access Point Manual page 9

Wireless Point to Multi-Point Configuration
Access Point 1
Access Point 2
Repeat the steps for Access Point 2 on each of the other Access Points, making sure you take
note of all the MAC Addresses.
Once you have gathered all the MAC addresses, and Wireless Briding and Repeating has been
enabled on all the Access Points, go back to Access Point 1 and select the first profile you
enabled. Click on the Edit button at the bottom of the screen to change the details of the profile:
On Access Point 1, in the Wireless
•
Bridge Page, enable Wireless
Bridinging and Repeating and select
the option for Wireless Point to
Multi-Point Bridge.
❶
• Enable as many profiles as you have
Access Points; each profile will
associate your central Access Point to
one of the remote Access Points.
Make note of the MAC Adress of
•
Access Point 1:
On Access Point 2, in the Wireless
•
Bridge Page, enable Wireless
Bridinging and Repeating and select
the option for Wireless Point to
Multi-Point Bridge.
➋
• Enable one profile to associate this
remote Access Point to the central
location.
Make note of the MAC Adress of
•
Access Point 2:
❶
➋