Setup Using Wi-Fi Protected Setup (Wps); Setup Using Aoss - Nintendo CTRSKAAA Operation Manual

Setup using Wi-Fi Protected Setup (WPS)

Setup is easy if you use a wireless router that includes the WPS feature. Read the instruction manual for your router for ad-
ditional information on using the WPS feature.
If you are using the guided setup Tutorial, proceed to step 2.
Tap to begin WPS configuration.
1
Tap the connection method that matches your router.
2
On your WPS-compatible router, you will have either one of the following options:
3
NOTE: It may take up to two minutes to complete the connection.
Push-Button Connection
Hold down the WPS Button on the access point until the corresponding
light flashes.
OR
PIN Connection
Use the number displayed on the Nintendo 3DS screen to config-
ure your router, then tap Next.
4 When a Settings Complete screen appears on your Nintendo 3DS system, tap OK to run a connection test. If the
connection test succeeds, setup is complete.
NOTE: The connection test may fail if you try to connect immediately after finishing setup. Wait one or two minutes before trying
the connection test.
64
WPS Button

Setup using AOSS™

Setup is easy if you use a wireless router that includes the AOSS feature. This is found on many routers sold under the Buffalo™
brand name. Read the instruction manual for your router for additional information about using AOSS.
NOTE: If you use AOSS, your access point settings may sometimes change. Computers and other devices connected without
using AOSS sometimes lose the ability to connect to the Internet and may need to be reconfigured. (If you configure
your settings by using Search for an Access Point, your access point settings will not change.)
If you are using the guided setup Tutorial, proceed to step 2.
Tap to begin AOSS configuration.
1
On your AOSS-compatible router, press the AOSS button.
2
Hold down the AOSS button until the corresponding LED blinks twice.
If the connection fails repeatedly, wait about five minutes and try again.
3 When a Settings Complete screen appears on your Nintendo 3DS system, tap OK to run a connection test. If the
connection test succeeds, setup is complete.
NOTE: The connection test may fail if you try to connect immediately after finishing setup. Wait one or two minutes before trying
the connection test.
AOSS Button
65