Initial Camera Setup - Polaroid iD640 User Manual

When powering the camera ON for the first time the camera will take you through the initial
camera setup.
1) Charging Your Battery
To charge your battery, first connect the USB Cable to your camera.
Then follow one of the steps below:
A) Charge the battery using the USB connection cable (included) and your computer:
- Connect one end of the USB cable into the USB port on your camera.
- Connect the other end of the USB cable to the USB port on your computer.
B) Charge the battery using the USB connection cable (included) and the AC Adapter
(included).
- Connect one end of the USB cable into the USB port on your camera.
- Connect the other end to the AC Adapter and then plug the AC Adapter into a power
socket.
NOTE: While charging the battery, the LED light turns on. The battery is fully charged
when the LED light turns off.
Battery Power:

Some features, will not work if the battery power level is low.

When the battery power is low the battery icon turns red and the camera will
automatically turn off a few seconds later.

The energy status of the power is displayed on LCD as shown below:
Full battery power
2) SD Card
Make sure an SD card has been properly inserted into your camera. (SD card not included.)
To properly insert the SD Card:
Push the SD card into the slot in the direction shown on the camera (see SD icon by the SD
Medium battery power
5
Low battery power