Cannot Connect The Projector And The Computer Via Wired Lan; Cannot Connect The Projector And The Computer Via The Network - Epson PowerLite Pro G6050W Operation Manual

Solving Problems

Cannot connect the projector and the computer via wired LAN

Check
Is the network cable connected correctly?
Are the computer's LAN card and the built-in LAN function
available?
Is the DHCP function for Wired LAN turned On?
Are connection denial functions, such as MAC Address
restrictions and port restrictions, set correctly at the
access point?
Are the IP address, the subnet mask, and the gateway
address for the access point and the projector set
correctly?

Cannot connect the projector and the computer via the network

Check
Is the Network Configuration screen displayed on the
projector?
Is the firewall turned off, or has the firewall been
registered as an exception?
Was the network adapter being used selected correctly
with EasyMP Multi PC Projection?
Check that the network cable is securely connected.
Check that LAN is valid by checking the device manager under Control Panel - System - Hardware.
Turn off the DHCP setting for Wired LAN from the Configuration Menu before connecting.
When DHCP is set to ON in Advanced connection mode, if an available DHCP server is not found, it
may take a while to enter LAN standby status.
See your projector User's Guide for details on the projector's wired LAN settings.
Set the projector to allow connections from the access point.
When not using a DHCP, adjust each setting.
Close network settings on the projector, and return to the LAN standby screen. If the Network
Configuration screen is displayed on the projector, you cannot connect using EasyMP Multi PC
Projection.
When you do not wish to turn off the firewall or register the firewall as an exception, make the
necessary settings to open the ports.
The ports used by EasyMP Multi PC Projection are "3620", "3621", and "3629".
If the computer has multiple LAN environments, it cannot connect unless the network adapter is
selected correctly. When using a computer running Windows, start EasyMP Multi PC Projection, and
select the network adapter you are using from Switch LAN in Set options.
s "General Settings Tab" p.44
Remedy
Remedy
35