Using The Remote Control - Epson BrightLink 436Wi Manual

3 Calibrate
Calibration coordinates the position of the pen with the
location of your cursor. If the pen position and cursor
location don't match, you can try auto calibration, or you
can calibrate manually for even greater accuracy. You
don't need a computer, and you won't need to calibrate
again unless the projector or image is moved, or the
image is resized.
1
To start calibration, press the User button on the
remote control.
2
When you see the Auto Calibration screen, do one
of the following:
• Press Enter to try auto calibration, then wait until
calibration is complete.
• Select No, then press Enter and follow the steps
below to calibrate manually.
3
When you see this screen, select Manual
Calibration, then press Enter.
4
When you see this screen, press Enter to select
Yes.
5
 T ouch the circles on the screen to perform manual
calibration.
For more detailed instructions, see the on-screen
BrightLink User's Guide.
Using the Remote
Control
Turn projector
on/off
Access menu
system for
additional
adjustments
Calibrate
Page through
documents
Temporarily
turn off image
For more information on using the remote control and
cool time-saving buttons:
•
See the on-screen BrightLink User's Guide.
•
Go to the training section and watch a video or two at
epson.com/brightlinkvideos (U.S.) or
epson.ca/brightlinkvideos (Canada).
Select from various
image sources
connected to the
projector
Switch between
computer and Easy
Interactive Pen
Enter
Zoom in and out
Stop video action