Call.configuration - D-Link DIV-140 User Manual

Analog trunk gateway
Hide thumbs Also See for DIV-140:
Table of Contents

Advertisement

Timeout:
Various. constants. which. are. used. during. the. call. setup. (like.
maximum.timeout.or.number.of.rings).can.be.configured.in.this.
section.
Dial Timeout:
Enter.the.maximum.time.to.wait.for.a.user.to.dial.any.key.after.
going. off. hook.. After. this. timeout. is. reached. an. error. tone.
is. played. to. the. user.. Range:. 5. to. 120. seconds.. Default:. 15.
seconds.
Connection Timeout:
Enter.the.maximum.time.to.wait.to.get.any.response.from.the.
other. end.. During. this. period. a. progress. tone. is. played. and.
after.the.timeout.limit.is.reached.an.error.tone.is.played.to.the.
user..Range:.5.to.180.seconds..Default:.45.seconds.
Alerting Timeout:
Enter.the.maximum.time.to.play.a.ring.back.tone.for.outgoing.
calls. when. the. called. party. starts. ringing.. For. incoming. calls.
this.field.defines.how.long.the.phone.will.ring.when.user.doesn't.
answer..Range:.5.to.120.seconds..Default:.60.seconds.
Interdigit Timeout:
Enter.the.maximum.time.to.wait.in.between.digits.while.dialing.
the. number.. After. this. timeout,. further. digits. are. ignored. and.
the.collected.digits.will.be.dialed.out..Range:.1.to.120.seconds..
Default:.5.seconds.
Interdigit Time
Enter.the.time.between.digits.while.dialing.out.the.received.number.on.FXO.line.using.DTMF.tones...Range:.50.to.1000.milliseconds..Default:.300.
while Dialing:
milliseconds.
FXO Rings:
Enter.the.number.of.rings.to.wait.before.going.off.hook.on.FXO.port.when.the.FXO.port.is.ringing..Range:.1.to.9.rings..Default:.2..
Note:.If.this.field.is.configured.as.1.then.caller.ID.detection.on.the.FXO.port.won't.work.
Dial Termination:
Here.you.can.configure.if.any.special.DTMF.key.like.*.or.#.to.use.for.terminating.the.dialed.number.while.placing.outgoing.call..Note.that.Inter.
Digit.timeout.will.be.always.active.
Character Termination:
Select.enable.if.you.want.to.terminate.the.dialed.number.using.a.DTMF.key,.otherwise.select.Disable..Default:.Enable.
If.character.termination.is.enabled.then.you.can.also.terminate.the.feature.access.keys.with.this.
D-Link DIV-140 User Guide
Call Configuration
1

Advertisement

Table of Contents
loading

Table of Contents