Jumper Settings - Asus P I-P6NP5 User Manual

III. INSTALLATION

Jumper Settings

1. On-Board Multi-I/O Selection (JP10)
You can disable the onboard Multi-I/O (floppy, serial, parallel, and IrDA)
through BIOS or entirely with the following jumper in order to use your
own Multi-I/O card.
Selections JP10
Enable [1-2] (Default)
Disable [2-3]
2. Flash ROM Boot Block Programming (JP13)
This sets the operation mode of the boot block area of the BIOS Flash
ROM to allow programming in the Enabled position.
Programming
Enabled
Disabled
1
2
3
Enable (Default)
Multi I/O Setting (Enable / Disable)
JP13
[2-3] (Default)
[1-2]
Enable (Default)
Boot Block Programming (Disable / Enable)
P/I-P6NP5 User's Manual
Disabled
1
2
3
Disabled
7