ASROCK 960GC-GS FX User Manual page 24

For Windows
Go to the "FrontMic" Tab in the Realtek Control panel. Adjust
"Recording Volume".
SPDIF Out Connector
(2-pin SPDIF_OUT1)
(see p.12 No. 24)
System Panel Header
(9-pin PANEL1)
(see p.12 No. 19)
Connect the power switch, reset switch and system status indicator
on the chassis to this header according to the pin assignments below.
Note the positive and negative pins before connecting the cables.
PWRBTN (Power Switch):
Connect to the power switch on the chassis front panel. You may con-
figure the way to turn off your system using the power switch.
RESET (Reset Switch):
Connect to the reset switch on the chassis front panel. Press the reset
switch to restart the computer if the computer freezes and fails to per-
form a normal restart.
PLED (System Power LED):
Connect to the power status indicator on the chassis front panel. The
LED is on when the system is operating. The LED keeps blinking
when the sys-tem is in S1 sleep state. The LED is off when the system
is in S3/S4 sleep state or powered off (S5).
HDLED (Hard Drive Activity LED):
Connect to the hard drive activity LED on the chassis front panel. The
LED is on when the hard drive is reading or writing data.
The front panel design may differ by chassis. A front panel module
mainly consists of power switch, reset switch, power LED, hard drive
activity LED, speaker and etc. When connecting your chassis front
panel module to this header, make sure the wire assignments and the
pin assign-ments are matched correctly.
®
8 / 8 64-bit / 7 / 7 64-bit / Vista
1
GND
SPDIFOUT
24
TM TM
/ Vista 64-bit OS:
Please connect the
SPDIF_OUT connector of a
HDMI VGA card to this header
with a cable.
This header accommodates
several system front panel
functions.