Advertisement
BASIC OPERATIONS (CONT.)
11. Scanning (fast forward / Fast reverse)
• This function allows a fast search through a disk or track. Turning the
Outer Shuttle wheel in clockwise direction will fast forward your search.
Turning the Outer Shuttle wheel in a counter-clockwise will fast reverse
your search. You can scan in 6 different speeds (3 forward/3 reverse)
depending on the degree you turn the shutter wheel.
12. Seamless Loop Play
• A seamless loop is a sound loop that plays continuously without
sound interruption.
• You create a seamless loop between any two continuous points in a CD.
(1) Press the PLAY BUTTON to start a CD playing.
(2) Press IN/LOOP BUTTON. This sets the loops' starting point. The
IN/LOOP LED will begin to glow (Fig. 15).
(3) Press OUT/LOOP BUTTON to set your desired loop ending point.
The IN/LOOP and OUT/LOOP LEDs will flash indicating SEAMLESS
LOOP mode has been activated.
• LOOP INDICATOR
(1) The loop indicator will display in the LCD display indication that a
loop is running.
• Exiting A LOOP
(1) To Exit a SEAMLESS LOOP, Press the OUT/LOOP BUTTON. The
IN/LOOP and OUT/LOOP LEDs will remain on, but will stop
flashing. Music will resume normal play (Fig. 16)
• REPLAY LOOP
(1) To replay the loop, press the RELOOP BUTTON. The IN/LOOP and
OUT/LOOP LEDs will again begin to flash indicating SEAMLESS
LOOP MODE has been activated (Fig. 17).
13. Editing A Loop:
• Note: You can only edit the ending point of the loop.
• Before you can edit a seamless loop you obviously, must first be in SEAMLESS LOOP mode.
• If a SEAMLESS LOOP has not yet been created, follow instructions above (SEAMLESS LOOP PLAY) to create a
SEAMLESS LOOP. If a SEAMLESS LOOP has already been created, press the RELOOP BUTTON to reenter the
SEAMLESS LOOP mode (Fig. 17).
1) Press the OUT/LOOP BUTTON to return to normal play from the loops cue point. (Fig. 16). This
disengages the SEAMLESS LOOP mode and allows you to edit the loops ending point.
2) Press OUT/LOOP BUTTON again for a new loop ending point (Fig. 16).
3) FOR A SHORTER LOOP: Press the OUT/LOOP BUTTON at sooner point in the track.
4) FOR LONGER LOOP: Press the OUT/LOOP BUTTON at later point in the track.
14. Program play
• Press the PROGRAM button, the player will enter the program mode and the CD will stop rotating.
• Select the desired track by pressing the SKIP button, then press the PROGRAM button again. The
selected track will be added to the program sequence.
• Repeat step 2 operation. A maximum of 30 tracks can be programmed at one time.
• Press the PLAY button to start the program play from the first selection.
• Press the program button again during program play to stop play.
• Press and hold the program button more than 2 seconds to cancel the program mode and erase all
the current program contents.
American DJ
AUDIO • DCD-PRO250™ INSTRUCTION MANUAL • PAGE 14
®
DISC 1
5
PLAY
DISC 1
5
PLAY
DISC 1
5
PLAY
Fig. 17
TIME
RE
Fig. 15
TIME
REM
Fig. 16
TIME
RE
Advertisement
