Running The Self Test With Slip Paper; Setting The Dip Switches - Epson TM-U950P - B/W Dot-matrix Printer Operator's Manual

Running the self test with slip paper

Note:
Be sure to install both paper rolls to prevent slip paper jams.
1. Make sure the printer is turned off and the printer cover is
closed properly.
2. While holding down the JOURNAL/SLIP FEED button, turn on
the printer to begin the self test. (The SLIP light blinks.)
3. Feed a sheet of slip paper into the printer. The printer loads the
paper automatically, prints the printer settings, and then ejects
the paper. (The SLIP light blinks.)
4. Remove the paper from the printer and feed another sheet of
slip paper into the printer to print characters from the character
table. Continue to feed slip paper into the printer until the self
test prints the following:
The printer is ready to receive data as soon as it completes the self
test.
Note:
If you want to pause the self test manually, press the
JOURNAL/SLIP FEED button. Press the JOURNAL/SLIP
FEED button to continue the self test.

Setting the DIP Switches

CAUTION:
Turn off the printer while removing the DIP switch cover to
prevent an electric short, which can damage the printer.
1-20 Setting Up the Printer
***completed***