Removing Memory; Pci Cards; Installing A Pci Card - Dell XPS /Dimension Gen 4 Service Manual

6. Close the computer cover.
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
7. Connect your computer and devices to electrical outlets, and turn them on.
8. Right-click the My Computer icon and click Properties.
9. Click the General tab.
10. To verify that the memory is installed correctly, check the amount of memory (RAM) listed.

Removing Memory

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.
1. Follow the procedures in "Before You
2. Press out the securing clip at each end of the memory module connector.
3. Grasp the module and pull up.
If the module is difficult to remove, gently ease the module back and forth to remove it from the connector.
Cards
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.
Your computer provides the following slots for PCI and PCI Express cards:
Four PCI card slots
l
One PCI Express x16 card slot
l
One PCI Express x1 card slot
l

PCI Cards

If you are installing or replacing a card, follow the procedures in the next section. If you are removing but not replacing a card, see
If you are replacing a card, remove the current driver for the card from the operating system.
If you are installing or replacing a PCI Express card, see

Installing a PCI Card

1. Follow the procedures in "Before You
2. Press the lever on the card retention arm and raise the retention arm.
Begin."
"Installing a PCI Express
Begin."
Card."
"Removing a PCI Card."