Display Assembly - Dell D810 - Latitude D820, D830 Series 15.4" WXGA LCD Screen Service Manual

Back to Contents Page
Display Assembly
Dell™ Latitude™ D810 Service Manual
Display Assembly
Display Bezel
Display Panel
Display Assembly
CAUTION: Before performing the following procedures, read the safety instructions in your Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE: You must remove the display assembly before you remove the palm rest.
1. Follow the instructions in "Preparing to Work Inside the
2. Turn the computer over and remove the two M2.5 x 8-mm screws labeled "D" on the bottom of the computer.
3. Turn over the computer and open the display.
4. Remove the center control cover.
5. Disconnect the display cable using the pull-tab, and release the cable from the cable-routing guides.
6. Remove the antenna cable connector from its pocket on the computer base, and then gently disconnect the connector.
7. Lift the display straight up out of the computer base.
Computer."