FujiFilm Finepix FinePix Z5fd Owner's Manual page 138

Troubleshooting
Matters
Cannot use the
flash.
Flash
The flash settings
are restricted and
cannot be
selected.
The playback
image is dark
even though the
flash was used.
The image is
blurred.
Photographed images
There is speckling
on the image.
138
Problems Possible causes
The shutter button was pressed while the
flash was charging.
The SHOOTING MODE is set to
,,
, , or
The battery has run out.
Continuous shooting is selected.
The flash mode is set to C.
The SHOOTING MODE is set to
AUTO, ,
, , ,
The subject is too far away.
Your finger was covering the flash.
The lens is dirty.
{ appeared when taking pictures.
| appeared when taking pictures.
The picture was taken with a slow shutter
speed (long exposure) in a high-
temperature environment.
,
.
, ,, ., /,
, , ,
, , or .
Solutions
Wait until the charging is completed before
pressing the shutter button.
Change the Shooting mode.
Charge the battery or load fully charged
battery.
Set continuous shooting to OFF.
Set the flash mode to something other
than C.
The flash settings are restricted because
the camera settings are tailored to the
scene being shot. Change the Shooting
mode for a wider range of flash settings.
Move to within the effective flash range
before taking the picture.
Hold the camera correctly.
Clean the lens.
Check the focus on the subject and take
pictures.
It may cause camera shake. Hold the
camera steadily.
This is a characteristic of CCDs and does
not indicate a camera fault.
Page
50
42
14,
16,
126
62
49
42
48, 50
25
125
26,
28,
131
27,
131
–