Sharp AQUOS LC-22SV2E Operation Manual page 32

Useful Features (Continued)
T T T
SUBPAGE SUBPAGE
MENU OK
SOUND SOUND
CH CH
TV/VIDEO TV/VIDEO
30
AV Connections (Continued)
[2] For programmes
• The influence of the AV control voltage and of fast blank at programme
positions from 1 to 199 can be set.
• When connecting a video device to the AV1 terminal, you need to adjust the
decoder programme settings.
1 1
Perform steps 1 and 2 in
</>
[1] AV1/AV2 to display the "AV
connections" screen.
2
2
Press ]/[ to select "For
programmes", and then press OK
END
E E
to display the "For programmes"
screen.
MENU MENU
MENU
M M
]/[
3
3
Press ]/[ to select the "AV
control voltage" or "RGB On-screen
OK
disp.".
4 4
Press </> to select "yes" or "no".
• If the item concerned is set to "yes",
5 5
Press ]/[ to select "For decoder
at AV1", and then press OK to
display the decoder programme
selection screen.
6
6
Press ]/[ and/or </> to select
the programme for the decoder,
and then press OK. Repeat the
same procedure if you want to
specify other decoder programmes.
7
7
Press MENU to return to the "For
programmes" screen.
8
8
Press ]/[ to select "Sound from
AV1", and then press </> to select
the desired sound source.
9
9
Press END to exit.
Note:
the appropriate picture is through-
connected at all programme positions
from 1 to 199 when a control voltage/
an RGB signal is applied.
AV connections
AV1
AV2(Y/C)
AV2(CVBS)
For programmes
M Back E End
OK
For programmes
AV control voltage [ no]
RGB On-screen disp.[yes]
For decoder at AV1
Sound from AV1 [Dec.]
Back End
M E
OK
For programmes
AV control voltage [ no]
RGB On-screen disp.[yes]
For decoder at AV1
Sound from AV1 [Dec.]
Back End
M E
OK
For decoder at AV1
0 8 SHARP
1 E 2 0 9 ZDF
2 E 4 0 1 0 ARD
3 U 2 0 11 RTL
4 U 4 0 12 SAT1
5 E 5 0 13 Pro7
6 E 8 0 14
7 E1 0 15
Back End
M E
OK
For programmes
AV control voltage [ no]
RGB On-screen disp.[yes]
For decoder at AV1
Sound from AV1 [Dec.]
Back E End
M
OK