Setting Up For Windows; Hardware And Software Requirements; Before Installation - Sharp AJ-2100 Operation Manual

Colour inkjet printer
Table of Contents

Advertisement

SETTING UP FOR Windows

To use this printer with your computer, the printer driver should be installed onto your computer's
hard drive. In this chapter, you will learn how to install them and how to use the Online Manual.
The following terms are used in this chapter.
CD-ROM
Means the supplied CD-ROM with the AJ-2100 Series Software.
Drive D (the field to be typed "D:\...")
This assumes that your computer's CD-ROM drive is drive D.
(If your computer's CD-ROM drive letter is not Drive D, change the CD-ROM drive letter
to correspond to the letter of your CD-ROM drive.)
Be sure to read the Readme.txt file before installing the printer driver.
(The location of the Readme.txt file is D:\README\ENGLISH\README.TXT)

HARDWARE AND SOFTWARE REQUIREMENTS

Check the following hardware and software requirements in order to install the AJ-2100
Series Printer Driver.
Computer type
Operating system
Display
Hard disk free space
Other requirement for hardware
* Compatible with Windows 98 or Windows 2000 preinstalled model with USB interface
equipped as standard.

BEFORE INSTALLATION

The method to install the printer driver varies depending on your operating system and the
cable connecting the printer and your computer. Check your operating system and your
cable type, and then follow the steps shown below to install the printer driver.
Operating system
Windows 98
Windows 95
Windows 2000 *
Windows NT 4.0 *
* The administrator's authorisation is required to install a printer driver.
20
Interface
USB
"Installing the USB driver (Windows 98)" (page 21)
next, step 6 and later of "Installing onto Windows 95 / 98" (page 26)
Parallel
"Installing onto Windows 98 (Parallel interface) / 2000" (page 22)
Parallel
"Installing onto Windows 95" (page 24)
USB/Parallel
"Installing onto Windows 98 (Parallel interface) / 2000" (page 22)
Parallel
"Installing onto Windows 2000 / NT 4.0" (page 29)
IBM PC/AT or compatible computer equipped with a
USB* or bi-directional parallel interface (IEEE 1284)
Windows 98, Windows 95, Windows 2000,
Windows NT 4.0 (Service Pack 3 or later)
640 x 480dots (VGA) or better
10MB or more
An environment on which any of the operating
systems listed above can fully operate
Reference pages for how to install

Advertisement

Table of Contents
loading

This manual is also suitable for:

Aj-1800Aj-2000

Table of Contents