Advertisement
HOW TO USE
MECHANICAL TEMPERATURE ADJUSTMENT
RL24MB
Season switch
Temperature adjustment
RL26MB
WARM
Season switch
Temperature adjustment
FRUIT AND VEGETABLE COMPARTMENT
1.
You may adjust the moisture of the fruit and vegetable compartment by the moisture control
slide. The slide towards the two sides may increase the moisture, vice versa.
2.The partition of the fruit and vegetable tray separates the fruit and vegetable compartment
into two parts. You are allowed to adjust it according to the fruit and vegetable types and
quantities to meet a satisfactory need of storage space.
Cover
Moisture
control slide
Partition
Fruit and vegetable tray
Caution:
Tropical fruits, such as banana and pineapple are not recommended.
The temperature is adjusted by the slide under the
control of temperature controller. The signs,
strong , mediate and weak , on the knob receptively
indicate the inside temperature condition. Under the
same circumstance, stronger the knob reflects, lower
the inside temperature is. Close means stopping
working.
In normal use, adjust the slide at the mediate and
change it to the location between weak and mediate
if any hot weather. If the room temperature is below
15
, then open the season switch and change the
slide to the location between mediate and strong .
If the room temperature is below 10
, it's a must to
locate the slide at the Winter area.
The fruit and vegetable compartment is able to
preserve the water content and freshness of the
fruits and vegetables as it is sealed to prevent cold
air touching the fruits and vegetables.
It is appropriate to the storage of vegetables and
fruits.
8
DISASSEMBLING PARTS
Refrigerator shelf
Lift the shelf head and pull it out. (Position the
shelf as per the container height)
Fruit and vegetable tray and cover
Draw out the fruit and vegetable tray.
Lift up the cover head to pull it out.
Freezer tray
Draw out it till the block, lift the shelf rear and
pull it out.
Egg guard and bottle guard
Lift them up to take them down.
CHANGE THE INTERIOR LAMP
Pull out the plug
Turn off the screw in the lampshade inner wall
hold the lampshade with palm and push forward
to take out the lampshade.
Turn off the lamp counterclockwise.
Screw on the lamp clockwise.
Hang on the hook under the cover and turn
upward to push into the upper hook. Afterwards,
refit the screw into the lampshade interior wall.
Lamp parameter: 220V/240V, 15W
5
Advertisement
