Table of Contents
Advertisement
3-6. LCD KIT Assembling Procedure
1
2
1
3
Check the (1)Hot Bar, (3) Backlight
FPCB, (2) Heat seal and (4)Guide
poles
3
Check the condition of HOT BAR by a magnifying glass
4
OK
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
2
1. Remove the double-sided tape on
Sub PCB by tweezer.
2. Align the guide holes on hot bar
FPCB with guide silk on Sub PCB.
3. Paste the flux evenly on the
solder PAD .
4. Solder by the soldering iron
5. Check the soldered condition
NG
FILLET should be formed
3-21
Exploded view and its Part list
Advertisement
Table of Contents
