Table of Contents
Advertisement
Disassembly and Assembly Instructions
9
B R K G U I D E P I N
S o l d e r i n g
S I D E K E Y
R R K S C R E W
Soldering SIDE KEY and attach BRK
1. Solder the SIDE KEYs along the each guide
hole.
2. Put the BRKs to both sides along the guide
pin hole and then screw up the BRK screws.
11
Soldering MOTOR
1. Solder the MOTOR pad.(Check +,- mark)
2. Put some yellow glue on the soldering point.
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
10
B A S E T A P E
Attach the SIDE KEY and the BASE TAPE
1. Attach the SIDE KEY FPCBs on the BRK along
the guide.
2. Attach the BASE TAPE for the SLIDE F-PCB.
12
Assemble REAR INTENNA
1. Put the INTENNA to rear case. (Check the HOOK for
intenna)
2. Put the SCREW to screw hole for intenna.
11-8
S C R E W
I N T E N N A H O O K
Advertisement
Table of Contents
