Related Manuals for Frigidaire Coin- Operated Commercial Tumble Action Washer
Summary of Contents for Frigidaire Coin- Operated Commercial Tumble Action Washer
- Page 1 Coin- Operated Commercial Tumble Action Washer Installation Instructions and Use and Care Guide P/N 134778000 (0706) Made in USA...
-
Page 2: Table Of Contents
Your washer is equipped with a door safety interlock. Verify proper operation of interlock system daily, using the following procedure: 1. With the washer door open, insert the required number of coins and press the START button. THE WASHER MUST NOT START! 2. -
Page 3: Important Safety Instructions
• Do not put oily or greasy rags or clothing on top of the washer. These substances give off vapors that could ignite the materials. • Do not add gasoline, cleaning solvents, or other flammable or explosive substances to the wash water. These substances give off vapors that could ignite or explode. -
Page 4: Pre-Installation Requirements
3. The standpipe height above the floor should be: NOTE: Drain hose attached to the washer can reach a 58 in. (147 cm) high standpipe. For higher standpipe use hose P/N 134592701, available from an authorized parts distributor. If drain is less than 24 in. -
Page 5: Rough-In Dimensions
< SIDE inch (cm) (11.2) > < (20.4) UNDER COUNTER inch (cm) (Figure 1). > (43.2) POWER CORD WATER INLETS BACK... -
Page 6: Unpacking
UNPACKING 1. Cut the shipping carton along the dotted line along the base of the unit. 2. While in the carton carefully lay the washer on its back side. 3. Removethe styrofoam base. 4. Carefully return the washer to an upright position and remove the carton. -
Page 7: Installation
Cable 6. Carefully move the washer to its final location. NOTE: Do not use the dispenser drawer or door to lift washer. Excessive noise and vibration can be prevented by properly leveling the washer. 7. For free standing installation and with the washer in it’s final position, place a level on top of the washer. - Page 8 STEP 3 Remove coin slide from coin chute: • Unhook and remove the coin slide return spring. (see FIGURE 2). • Turn coin slide mechanism upside down. • Remove coin slide stop by taking out two screws to the chute bottom (see FIGURE 3).
-
Page 9: Meter Case Instructions
Change coin sizing block: • Remove two screws that hold upper coin chute cover. Remove cover (see FIGURE 9). FIGURE 9 (2) Upper Coin Chute Cover Screws (2) Coin Sizing Block Screws FIGURE 10 • Remove two screws that hold coin sizing block to upper coin chute cover cover (see FIGURE 10). -
Page 10: Replacement Parts
If replacement parts are needed for your dryer, contact the source where you purchased your dryer, or call Frigidaire at 1-866-738-1640. For coin box parts, call 1-800-221-0982, Greenwald Industries. Destroy the carton and plastic bags after the washer is unpacked. Children might use them for play. Cartons covered with rugs, bedspreads, or plastic sheets can become airtight chambers causing suffocation. -
Page 11: Parts Lists
———————————————————————————— 33 MAGNET Opt. 00-9256 ———————————————————————————— 34 SHIELD Opt. 20-2045 ———————————————————————————— 35 COIN RECEIVER BLOCK --------- ———————————————————————————— 37 LOCK WASHER --------- ———————————————————————————— 38 SCREW (METRIC) --------- ———————————————————————————— 39 SCREW (METRIC) --------- ———————————————————————————— 40 SCREW 00-7541 ———————————————————————————— 41 TOP HOUSING ASMY 20-1103-1 20-1104-1 ————————————————————————————... -
Page 12: Warranty
____________________________________________________________ Order Form To change vend price, detach and mail the lower portion to: Customer Service Department Greenwald Industries Inc. 212 Middlesex Ave. Chester, CT 06412 ____________________________________________________ The coin chute has been pre-set at the factory. When increasing in $.25 pricing Follow product information instructions;...