Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Standard Horizon SL150
Summary of Contents for Standard Horizon SL150
- Page 1 SL150 Digital Speed Log Owner’s Manual Marine Division of Vertex Standard...
-
Page 2: Limited Warranty
To obtain warranty service, the defective product must be returned to STANDARD HORIZON together with proof of the date of purchase. The Purchaser must pay any transportation expenses in returning the product to STANDARD HORIZON. STANDARD HORIZON will examine the product and respond to the Purchaser in approximately four (4) weeks from date of receipt of the product claimed to be defective. -
Page 3: Table Of Contents
5.4.2 Temperature On/Off ..................10 5.4.3 Temperature Calibration ................... 10 5.4.4 Tenths or Hundredths Select ................10 5.5 Simulation Mode ..................10 5.6 Microprocessor Reset ................10 6 Maintenance ...................... 10 7 Specifications ....................11 8 Troubleshooting ....................11 SL150 User Manual... -
Page 4: General Information
Note: Please familiarize yourself with the entire manual and transducer installation guide before attempting installation. 1.1 Introduction 1.2 Front panel The SL150 is a high quality digital speed log. It The front panel includes a multi-function LCD and mounts into a 1¼" (32mm) diameter instrument three-button keypad. The keypad uses both tactile hole. -
Page 5: Accessories
SIA53 ........................Thru-hull Speed Impeller EX345 ......................15-foot Impeller Extension Cable 3.2 Replacement Parts The following parts may be ordered from the Standard Horizon Parts Department. To order, call: 562-404-2700 Ext 351 Part ............................Part Number Dummy Plug, SIA ........................356002017A Dust Cover ............................ -
Page 6: Wiring Connection
Transducer 4.5 Impeller Installation Transom-mount and thru-hull impellers can be used with the SL150. See section 3 for a list of available impellers. Specific installation instructions are supplied with each impeller. Note: It is wise to check the operation of the impeller before installation. -
Page 7: Operation
5.1.5 Reset Total Log With the total log value displayed, press and hold keys for fifteen seconds to reset the value to zero. SL150 User Manual... -
Page 8: Trend Indicator
Press the key to exit to the speed indicator. START To reset the countdown timer, press and hold the keys for three seconds while the countdown timer is displayed. The display will return to the start value selection. SL150 User Manual... -
Page 9: Secondary Functions
TENTHS OR HUNDREDTHS SELECT TO EXIT AT ANY TIME EXIT If no key is pressed for 10 seconds, the instrument will automatically exit secondary mode and return the display to normal. Changes made will not be saved. SL150 User Manual... -
Page 10: Speed Calibration
“0.00” will be displayed. 3 SEC DISPLAY Press the key to exit. 5.5 Simulation Mode The SL150 has a simulation mode. To increase reading press the key. To enter this mode, hold down the key and To decrease reading press the key. -
Page 11: Specifications
• 10k ohm NTC at 25°C (77°F). increments. NMEA Outputs Speed units and resolution • The SL150 outputs the following NMEA0183 • 0.0 to 19.9 and then 20 to 50 in knots, MPH or data sentences; DBT, VHW, VLW, MTW, KPH. - Page 12 Marine Division of Vertex Standard 17210 Edwards Road Cerritos, CA 90703 EED4100BD Telephone: 562/404-2700 STANDARD HORIZON ALL RIGHTS RESERVED PRINTED IN NEW ZEALAND 1950753A FEBRUARY 2001 MN000017...