Table of Contents
Advertisement
MST660 I.M.-2
21/12/99 1:26 PM
Flush Mounting
The MST660 can be neatly flush mounted into a panel or bulkhead so that just
the controls and the protective cover are visible. There are two flush mounting
options available. The best option for you will depend on your particular
situation.
•
If the space behind the bulkhead or panel you have selected has a suitable
support shelf and the area is fully accessible, you can use the supplied
escutcheon panel as described later.
•
If the space behind the bulkhead or panel is largely inaccessible or there is
no additional support shelf, we recommend you use the optional CMB60
flush mounting kit (available as an accessory). This kit is more robust, is
fully self supporting and allows the MST660 to be installed from the front.
Installation using the supplied Escutcheon Panel.
1. Select a suitable location on a panel or bulkhead. Examine behind the
bulkhead to determine the best method of support for the CD player.
2. Place the escutcheon on the panel or bulkhead in the required position
and mark around the outside edge of the escutcheon slot wall.
3. Remove the escutcheon and measure the marks. They should measure
approximately 7.87'' wide and 2.76'' high. If not, check the diagram above
to ensure that you measured the correct edge.
MST660
Page 9
Using the Optional Flush Mounting Kit
7.87"
IMPORTANT DRAW
AROUND THIS EDGE
Owner's Manual
Escutcheon
Page 7
Advertisement
Table of Contents
