Getting Started; Radio Care; Batteries And Chargers - Standard Horizon HX760S Owner's Manual

Standard horizon floating marine transceiver with bluetooth owner's manual
Hide thumbs Also See for HX760S:
Table of Contents

Advertisement

4. GETTING STARTED

4.1 RADIO CARE

Before following the instructions below, insure the speaker microphone
jack, antenna and battery are in place and firmly tightened. Care must
be taken if the radio was dropped and a close inspection may be needed
to insure the radio case and gaskets are in adequate condition.
Clean the radio with fresh water after exposure to salt water by rinsing the
radio under a sink faucet or by dunking the radio in a bucket of fresh water.
After washing, use a soft cloth and thoroughly dry all parts of the radio. This is
to keep the rubber switches and speaker grill clean and in top operating condi-
tion.

4.2 BATTERIES AND CHARGERS

If the radio has never been used, or its charge is depleted, it may be charged
by connecting the CD-39 Charger Cradle with the NC-88B battery charger, as
shown in the illustration. If 12V DC power is available, the optional E-DC-19A
DC Cable with 12 V Cigarette Lighter Plug or the optional E-DC-6 DC Cable
may be used for charging the battery. The NC-88B, E-DC-19A, and E-DC-6
will charge a completely discharged FNB-V99LI battery pack in about 8 hours.
The FNB-V99LI is a high performance Li-Ion battery providing high capacity in
a compact package.
To avoid risk of explosion and injury, FNB-V99LI battery pack should
only be removed, charged or recharged in non-hazardous environments.
4.2.1 BATTERY SAFETY
Battery packs for your transceiver contain Li-Ion batteries. This type of battery
stores a charge powerful enough to be dangerous if misused or abused, espe-
cially when removed from the transceiver. Please observe the following pre-
cautions:
DO NOT SHORT BATTERY PACK TERMINALS: Shorting the terminals that
power the transceiver can cause sparks, severe overheating, burns, and bat-
tery cell damage. If the short is of sufficient duration, it is possible to melt
battery components. Do not place a loose battery pack on or near metal sur-
faces or objects such as paper clips, keys, tools, etc. When the battery pack is
installed on the transceiver, the terminals that transfer current to the trans-
ceiver are not exposed. The terminals that are exposed on the battery pack
Page 10
CAUTION
CAUTION
HX760S

Advertisement

Table of Contents
loading

Table of Contents