Control Panel - THOR VL9000 Operation Manual

Control Panel

A - Program knob
Turn this knob to choose the drying program you desire. This type of dryer
has 11 program options . For description of specific programs, refer to the list of
programs on Page 14. When the drying program is selected,the relevant indicator
light is on.
B - Start/Pause button
Gently touch this button to start the dryer. Gently touch this button again
during the operation of the dryer and the indicator light and display screen will
flash and the machine will be paused .Press the button again and the program
will continue .
C - Signal button
When the drying cycle has finished, an intermittent acoustic signal will
sound.Touch this button,the buzzer will be canceled.
D- Anti-crease button
If this additional function is selected, the anti-crease phase at the end of
the drying cycle is lengthened by 60 minutes. The laundry can be removed
at any time during the anti-crease phase.
E - Delicate button
During a program, the drying temperature and power will decrease and the
drying time will increase to take better care of the delicate laundry.
F- Delay button
Gently touch this button before a program starts. You may choose to start
the dryer after a preset time. The delay range is between 1 and 19 hours.
Every touch of the delay button will increment by one hour. When you pass 19
hours, the delay time will turn off. After a delay time is set, gently touch the
Start/Pause button to the start the delay operation and the indicator light will
flash.
Control Panel
G - Program progress display
Depending on the program selected, the drying stage reached is
shown by the indicator light on the control panel:
- Drying
- Ready to iron
- Airing
- End/Anti-crease
At the end of a program,the End/Anti-crease indicator light comes on.
The drum will continue to rotate at intervals to prevent laundry creasing, if you
do not wish to remove it immediately.
H - LED screen
The screen displays the remaining time for a program, the delay time and
other related information.
Note: The remaining time to start a program is the default time for the
program.
I - Maintenance displays
- Empty tank
- Clean filter
- Clean condenser
Important: After each drying cycle
– Clean the filter
– Drain the condensed water container(unless direct drain is installed)
(See section "Cleaning and maintenance")
J- Power button
Press this button to switch on the dryer.Press it again to switch it off.
D+E composite button and child lock function
During a program, press and hold down the D and E buttons simultaneously
for 3 seconds to set up the child lock function . The display screen will show
the remaining time and the lock alternatively, and the control panel will
lock. Press and hold down both buttons for 3 seconds once again and the child
lock will release.When the program is finished or the power is turned off during
the program, the child lock will release.