Installing The Network Camera With Wps - Edimax IC-3115W User Manual

If everything works as intended, you should see the POWER LED light up (and
the Ethernet LED, if an Ethernet cable is inserted). If not, please recheck
every step and try again, or ask your dealer of purchase for help.
Please note if you configured the network camera to switch LED lights off, the
two LED lights won't light up.

1.6 Installing the Network Camera with WPS

This network camera can establish a wireless connection with a wireless access
point by means of its hardware Wi-Fi Protected Setup (WPS) button.
To activate a WPS connection, press the WPS / Reset button on the network
camera for two seconds, the LAN/Wi-Fi/WPS LED will start flashing regularly.
Press the WPS button on the root wireless access point within 120 seconds. The
network camera and the wireless AP will automatically establish a secure WPS
connection.
When the connection is successfully established, the LAN/Wi-Fi/WPS LED will
light up and may flash irregularly, to indicate a connection has been made and
data is being transmitted.
WPS / Reset
9