Haier HLC24XLP2 User Manual page 22

Preset: Resetting MP3 relative
parameters to the default values.
Exit: Exit MP3MusicBox
interface.
[Time Shift] – The feature allows
the viewer to pause and record the
currently watched digital program
(ATSC or QAM) and resume to
the point where it was paused. Plug
the USB storage device to activate
the Time Shift selection in Feature
menu.
Note:
– Formatting a USB 2.0 storage
device will be needed. Save your
original data before formatting.
All the data stored in the USB
device will be erased after
formatting.
– Sleep timer will be suspended if it
had been set before Time Shift.
• USB Drive Storage Format:
Select to format the USB disk
and locate a fix area for Time
Shift function.
Note:
• Format process will take at
least 2 minutes. Please do
not turn off power or remove
USB disk during formatting.
• During formatting, a speed
test will be done on the USB
disk. If it fails, it means the
USB disk may not support
the Time Shift functions.
• Start Time Shift Recording:
Select to start the Time Shift
function.
Note:
• Please do not unplug the USB
storage device when the Time
Shift function is activated.
• Approximately 4GB memory
buffers could offer 180
minutes for 480i contents
or 30 minutes for 1080i
contents.
• Once 4GB of data gets
stored, the time shift function
will delete the stored data
and restart the buffering of
content. This occurs even for
USB devices larger than 4GB.
Note:
Time Shift limitations:
1. When the Time Shift feature
is activated, only the PLAY/
PAUSE/STOP/FWD/REV/
VOL+/VOL-/MUTE keys and
some basic operation keys
(ENTER/EXIT/navigation
keys) are available. When
a key is pressed and that
function is unavailable, the
dialog box shown below will
appear.
This Key Is Unavailable During Time Shift Operation !
2. Video playback may not
be smooth and skip if USB
recording speed does
not meet the minimum
requirements (for certain
1080i/p signals).
3. Do Not remove USB disk or
switch off the power during
Time Shift operations. It will
abort once the signal is lost.
4. Do Not remove the signal
source during Time Shift
operations.
5. Do Not quickly and
22
OK