Advertisement
Quick Links
®
DELUXE STROLLER
PUSHBAR™
Assembly Instructions
Model # 8135-199
picture similar
USA
Tools Required:
(phillips head
(adj. wrench)
screwdriver)
(flat head screwdriver)
KETTLER® International, Inc.
1355 London Bridge Road
Virginia Beach, Virginia 23453 USA
Email: parts@kettlerusa.com
Web Address: www.kettlerusa.com
Advertisement
Summary of Contents for Kettler DELUXE STROLLER PUSHBAR 8135-199
-
Page 1: Assembly Instructions
® DELUXE STROLLER PUSHBAR™ Assembly Instructions Model # 8135-199 picture similar Tools Required: (phillips head (adj. wrench) screwdriver) (flat head screwdriver) KETTLER® International, Inc. 1355 London Bridge Road Virginia Beach, Virginia 23453 USA Email: parts@kettlerusa.com Web Address: www.kettlerusa.com... - Page 2 For your safety This toy vehicle should be used for its intended purpose only, that is as a pushbar for a KETTLER tricycle. It should not be used in any other way, as this may be dangerous. The manufacturer cannot be held liable for damage or injury caused by incorrect use.
- Page 3 States. Any shipments made under this warranty will be shipped to the United States only. Any shipment outside of the United States will be at the sole cost of the customer. This KETTLER® Limited Warranty is a manufacturer’s warranty and is not changed or modi ed by additional warranties extended by individual retailers at the point of sale.
- Page 4 Checklist (soft canopy) (large metal tubing pieces) Hardware NOTE: ALL HARDWARE IS PREASSEMBLED TO THE CORRESPONDING PARTS USED IN EACH STEP.
- Page 5 NOTE: IF ATTACHING PUSHBAR TO ASSEMBLED TRIKE, SEAT MUST FIRST BE REMOVED THEN RE- ATTACHED AFTER COMPLETING STEP 1. NOTE: Make sure the spring clip clicks into place when inserting the push bar shell tube.
- Page 6 NOTE: Loosen slide adjusters before attempting to slide onto push bar arms by untwisting large knobs slightly.
- Page 8 NOTE: Secure canopy bar to arms (making sure that spring clip ‘clicks’ into place). Once secure, slide front of canopy over bar and attach back with hook and loop fastener.
- Page 9 NOTE: Snap the drink/snack tray into place. No hardware required.
- Page 10 IMPORTANT: spare part pieces do not include fastening material; if fastening material (bolts, nuts, washers, etc.) is required, this should be clearly stated on the order by adding the words „with fastening material.“ KETTLER® International, Inc. · 1355 London Bridge Road, Virginia Beach, VA 23453 For parts or service ONLY 1-866-804-0440. Send e-mail to parts@kettlerusa.com...
- Page 11 8849-300#02 © 2005 KETTLER®. All rights reserved. No part of this manual may be reproduced, stored in a retrieval system, or transmitted in any form, or by any means, such as electronic,mechanical, photocopying or otherwise, without prior written permission from KETTLER®.