Important Safety Instructions These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using this appliance. Your safety is of paramount importance. If you are unsure about any of the meanings of these warnings contact the Customer Care Department. General Safety Prior to Installation ¥...
Operation Before use Remove all securing tapes. Wash inside the or two days at the most. appliance with lukewarm water and bicarbonate of Fruit & vegetables: these should be thoroughly soda (5 ml to 0.5 litre of water). Do not use soap or cleaned and placed in the bottom salad bin.
Health and Safety Guidelines Because of consumer demand, preservatives have been removed from many pre-prepared foods. This together with the changes in shopping habits to a once-a-week shop, mean that safe handling and storage of food is even more important than ever. The following tips should help you to ensure that the food in your home is in as perfect condition as possible.
Maintenance and Cleaning Changing the light bulb Warning Before any maintenance or cleaning work Should the interior light fail to work, first switch off the is carried out, DISCONNECT the appliance appliance and disconnect from the electricity supply, from the ELECTRICITY supply. then replace the bulb as follows: Important 1.
Something not Working? Before contacting your local Service Force Centre check the following points. IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee. Symptom Solution No power to appliance...
Service and Spare Parts In the event of your appliance requiring service, or if you wish to purchase spare parts, please contact your local Service Force Centre by telephoning:- 08705 929929 Your telephone call will be automatically routed to the Service Force Centre covering your post code area. For the address of your local Service Force Centre and further information about Service Force, please visit the website at www.serviceforce.co.uk Before calling out an engineer, please ensure you have read the details under the heading ÒSomething Not...
Standard guarantee conditions EHP, undertake that if within 12 months of the date of purchase this Firenzi appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: ¥...
Technical Specifications DIMENSIONS Height 81,5 Width 59,6 Depth POWER SUPPLY VOLTAGE AND FREQUENCY 220-240 V / 50 Hz TOTAL POWER ABSORBED 70 W AVERAGE DAILY UNITS ELECTRICITY 0,47 kWh GROSS CAPACITY 142 l NET CAPACITY 140 l (*)This figure is based on standard test results in accordance with European Standard EN153. Actual consumption will depend on how the appliance is used and where it is located.
Electrical Connection If you fit your own plug, the colours of the wires in the WARNING mains lead of your appliance, may not correspond THIS APPLIANCE MUST BE EARTHED. with the markings identifying the terminals in your The manufacturer declines any liability plug, proceed as follows: should this safety measure not be Connect the Green and the Yellow (earth) wire to the...
Door reversal To reverse the opening direction of the door, proceed as shown in the figures: Attention After completion of the door reversing operation, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet.
Building-in instructions Before carrying out any work, remove the plug from Building in the appliance under a the power socket. worktop The dimensions of the recessed installation area Grid preparation must correspond with those indicated in the figure. Left door opening: Remove the left side (A) of the grid cutting it from the rear (see figure).
Page 14
2. Push the appliance into place. The plug socket N.B. The joint cover (B) is to be assembled after necessary for connection of the appliance to the having installed the appliance in the recess. electricity supply should be positioned, so that the plug is not placed in the recess.
Page 15
6. To mount the furniture door proceed as shown in UPPER PART OF KITCHEN FURNITURE PANEL the figures: LOWER PART OF KITCHEN FURNITURE PANEL clic clic...
Fitting the plinth Important For the efficient operation of the appliance, it is important that the original ventilation grid is used. ¥ For an opening height dimension A=820 mm and a plinth height dimension a=100 mm, the plinth may be fitted without adjustments. The same applies to an opening height dimension B=870 mm and a plinth height dimension b=150 mm.