Table of Contents
Advertisement
·
Covering joints during cooking will also prevent
splashing onto the interior surfaces. Removing
the covering for the last 20-30 minutes will allow
extra browning if required. Some large joints and
turkeys especially benefit by this method of
cooking, allowing the joint to cook through before
the outside is over-browned.
TO REMOVE THE WIREWORK RUNNERS
The wirework runners in both ovens can be removed
for cleaning.
1. Remove all shelves and furniture from the oven.
2. Hold the wirework at the bottom, unclip from the
cavity side and gently pull towards the centre of
the oven.
3. Unhook the runner at the top and remove it from
the cavity.
4. To replace, hook the wirework back into the oven
sides.
Ensure that the wirework runners are
firmly in place before refitting the oven
shelves.
CLEANING THE SHELVES, WIREWORK
RUNNERS AND GRILL/OVEN FURNITURE
All removable parts, except the grill pan handle, can
be washed in the dishwasher.
The meat tin, grill pan, grill pan grid, oven shelves
and wirework runners may be cleaned using a soap
impregnated steel wool pad.
soapy water will make cleaning easier.
REPLACING AN OVEN LIGHT BULB
Isolate the appliance from the electricity
supply before replacing the bulb.
The type of bulb required is a 300°C, 25 watt small
Edison Screw.
1. Make sure the appliance is cool before you
replace a bulb
2. Open the oven door and remove the shelves and
wirework runners.
Instructions on how to remove the wirework
runners are given on this page.
3. Pull the glass bulb cover towards you and then
pull it off. If necessary use a screwdriver to
carefully lever off the cover, taking care not to
damage the oven cavity.
4. Unscrew the bulb by turning it to the left.
5. Fit a new bulb and then replace the glass bulb
cover.
6. Refit the wirework runners and replace the oven
shelves.
7. Restore the appliance to the electricity supply and
reset the time of day.
Soaking first in hot
SIDE PANEL
37
CAVITY CENTRE
Advertisement
Table of Contents
