Adjusting Your Oven Temperature; Care & Cleaning - Frigidaire Dual Fuel Range Slide-in Models Use & Care Manual

Changing Oven Light
Be sure the oven is unplugged and all parts are COOL before replacing the oven light bulb. Do not turn the oven
light on during a self-cleaning cycle. High temperature will reduce lamp life.
An interior oven light will turn on automatically when the oven is opened. The oven light may also be turned on and off when
the door is closed by using the oven light switch located on the control panel or on the electronic oven control.
The oven light bulb is covered with a glass shield held in place by a wire holder. THIS GLASS SHIELD MUST ALWAYS BE
IN PLACE WHEN THE OVEN IS IN USE.
To Remove the "Hidden Bake" Cover
1. In order to remove the "hidden bake" cover, pull the back edge with one
hand about 1/2" inch and lift up the "hidden bake" cover with both hands.
(See picture)
2. When re-installing the "hidden bake" cover, be sure to put it all the way to
the back of the oven and lay it down on the 2 shoulder screws. Then push
the front edge of the cover in its place below the front bracket.
To have easier access to the "hidden bake" cover, you can remove the oven
door by following the instructions on previous page.
IMPORTANT: Always replace the "hidden bake" cover before the next use.
For instructions on how to adjust the oven temperature refer to the electronic oven control guide.
Care & Cleaning
To Replace the Light Bulb:
BE SURE OVEN IS COOL
1. Turn the power off at the main source.
2. Wear a leather-faced glove for protection against possible broken glass.
3. Replace bulb with a 40 Watt appliance bulb only.
4. For self-cleaning oven, press wire holder to one side to release glass shield, change bulb and be
sure to replace glass shield.

Adjusting Your Oven Temperature

(some models)
19