Prior To Initial Start-Up; Starting Up - Setting The Temperature - AEG Santo K81240i Operating Instructions Manual

Prior to Initial Start–Up
0 1. Please clean the appliance interior and all accessories prior to initial
start-up (see section: "Cleaning and Maintenance").

Starting Up - Setting the Temperature

0 1. Plug the mains plug into the mains socket.
2. Press ON/OFF button.
The green mains pilot indicator illuminates.
3. Press either the „+" (WARMER) or „-" (COLDER) button.
The temperature display switches over and the DESIRED temperature
currently set flashes on the temperature display.
4. Set the required temperature by pressing the „+" (WARMER) or
„-" (COLDER) buttons (see section "Temperature setting buttons"). The
temperature display will immediately show the changed setting.
Each time the button is pressed the temperature is adjusted by 1 °C.
3
From a food safety point of view +5 °C should be considered suffi-
ciently cold for storing food in the fridge.
5. Once the required temperature has been set, after a short period
(approx. 5 sec.) the temperature display will change and again indicate
the current ACTUAL temperature inside the fridge. The display will
change from flashing to continuous illumination.
The compressor will start and then run automatically.
Information! When the setting is changed, the compressor does not
start immediately if automatic defrosting is currently taking place.
3
As the storage temperature within the fridge is reached quickly you can
store food immediately after switching on.
Important! Wait until the freezer compartment has reached a tempera-
ture of –18 °C, before storing frozen food.
42