Table of Contents
Advertisement
Fault
Washing machine
vibrates during
operation or is
unsteady.
The suds in the main
wash cycle create too
much foam.
Water is leaking out
from under the
washing machine.
Fabric softener is not
added, compartment
À for fabric
softener is filled with
water.
Possible cause
The machine is not level.
There is very little washing in
the machine (e.g. only a bath
robe).
Water could not be comple-
tely pumped out before the
spin
- because there is a kink in
the outlet hose or
– the drain pump is blocked.
Probably too much washing
powder was used.
The inlet hose connections
are not tight.
The inlet hose has a leak.
The drain pump cover is not
tight.
Washing is caught in the
door.
Suction cap in the fabric
softener compartment is not
correctly fitted or is blocked.
Troubleshooting
Remedy
Adjust the feet according to
the installation and
connection instruction.
This does not hinder the
machine from functioning
correctly.
Check that the outlet hose is
correctly laid and if appli-
cable eliminate the kink or
clean the drain pump and if
necessary remove any
foreign bodies from the
pump housing.
Only use as much as the
washing powder manufac-
turer recommends.
Tighten the inlet hose
connections.
Check the inlet hose and if
necessary replace it.
Tighten cover by turning
clockwise.
Abort the program, remove
the washing caught in the
door, start a new program.
Clean the detergent
compartment, fit the suction
cap on firmly.
33
Hide quick links:
Advertisement
Table of Contents
