Nokia Image Viewer SU-5 User Manual page 13

4. Insert the AAA batteries (4) and slide the cover back in
place.
5. Check that the NTSC/PAL switch (5) is in the correct
position.
6. Insert the MMC card (6) in the slot with the contact
surface towards the top of the main unit (where the
buttons are).
Lock the card in by pushing it in. To release the card,
push it slightly in again.
7. Make sure that the RCA cable is in the provided notch
(7) and close the main unit.
8. Install the remote control battery as shown in the
picture below.
The Nokia Image Viewer remote control uses the provided CR2032 button
battery as a source of power. If the remote control battery is out of power, you
©
Copyright 2004 Nokia. All rights reserved.
13