Whirlpool WDT910SAYM User Instructions page 10

OPTION SELECTIONS
OPTIONS PURPOSE
Control Lock To avoid unintended
use of your
dishwasher, or cycle
and option changes
during a cycle.
CONTROLS AND
CYCLE STATUS
CONTROL PURPOSE
Press to start or
resume a wash cycle
Press to cancel
wash cycle
To follow the
progress of your
dishwasher cycle
10
DESCRIPTIONS
To turn on Lock, press and hold Control Lock for at least
3 seconds.
To turn off Lock, press and hold Control Lock for at least
3 seconds.
When Control Lock is lit, all buttons are disabled. If you press any
pad while your dishwasher is locked, the light flashes 3 times. The
dishwasher door can be opened while the controls are locked.
COMMENTS
If the door is opened during a cycle or the power is interrupted, the Start/Resume indicator
flashes. The cycle will not resume until the door is closed and Start/Resume is pressed.
Close the door firmly. The dishwasher starts a 2-minute drain (if needed). Let the dishwasher
drain completely.
Clean indicator glows when a cycle is finished.
If you select the Sani Rinse option, when the Sani Rinse cycle is finished, the "Sanitized"
indicator glows. If your dishwasher did not properly sanitize your dishes, the light flashes at the
end of the cycle. This can happen if the cycle is interrupted, or the water could not be heated to
the required temperature. The light goes off when you open and close the door or press
CANCEL.
USE WITH:
Anytime