Before You Start - Whirlpool 3360619 Installation Instructions Manual

Before you start...

Your safety and the safety of
others is very important.
We have provided many important
safety messages in this manual and on
your appliance. Always read and obey all
safety messages.
This is the safety alert
symbol. This symbol alerts
you to hazards that can kill or
hurt you and others. All safety
messages will be preceded by the safety
alert symbol and the word "DANGER" or
"WARNING". These words mean:
Check location where washer will be
installed. Proper installation is your
responsibility. Make sure you have
everything necessary for correct
installation.
Untape and
open washer
lid. Remove
packages
and hoses
from washer.
No. T20 Torx
screws
On coin-operated washers, front
access to the pump area is available
by removing the two, No. T20 Torx
screws and then removing the front
panel.
Important: Observe all governing
codes and ordinances.
PAGE 2
DANGER
You will be killed or seriously injured if
you don't follow instructions.
WARNING
You can be killed or seriously injured if
you don't follow instructions.
All safety messages will identify the hazard,
tell you how to reduce the chance of injury,
and tell you what can happen if the
instructions are not followed.
Single washer
Grounded
installations require
electrical outlet
30 cm (12 inch)
is required. See
minimum risers to
Electrical
provide an air
requirements.
cushion and
prevent noise and
damage to valves.
Maximum slope
under washer —
A floor drain should be provided
under the bulkhead. Prefabricated
bulkheads with electrical outlets,
water supply lines and drain facilities
should be used only where local
codes permit.
Do Not store or operate washer below
0°C (32°F) (some water may remain in
washer).
See Use & Care Guide for
"Winterizing" information.
Hot and cold water faucets must be
within 1.2 meters (4 feet) of the back
of the washer and provide water
pressure 690 kPa (10-100 PSI). A
pressure reduction valve should be
used in the supply line where inlet
pressure entering the building
exceeds 690 kPa (100 PSI) to prevent
damage to the washer mixing valve.
Level floor:
2.5 cm (1 inch).
Standpipe drain system: Needs a 5 cm
(two-inch) minimum carry-away
capacity of 64.4 liters (17 gallons) per
minute. Top of standpipe must be at
least 86.4 cm (34 inches) high and no
higher than 183 cm (72 inches) from
bottom of washer.
Support: Floor must be sturdy enough
to support loaded washer weight of
143 Kg (315 pounds).
Water heater: Set to deliver
60°C to 70°C (140°F to 160°F)
water to the washer.