Vax DUAL V-124 Instruction Manual page 8

Vax V-124 User Guide v5.qxd
www.vax.co.uk
Fill tank (A) with warm tap water (Fig.4/10).
Fig.4/10
CAUTION: Do not fill with water above 50°C.
Fill solution container (B) with Vax Ultra Carpet/
Upholstery Solution (Fig.4/11).
B
Fig.4/11
NOTE: DO NOT remove solution container from tank.
IMPORTANT: Do not use any type of wax with
!
your cleaner.
IMPORTANT: To assure proper results, use only
!
Vax carpet cleaning solutions.
Replace container cap and tighten.
Position bottom of tank onto cleaner using one hand on
each side of the tank to center it on the unit. Pivot the
tank towards the back of the unit (Fig.4/12).
Fig.4/12
8
operation
21/9/07 16:38 Page 8
Push the top of the tank and tank handle while supporting
the back of the unit with your other hand (Fig.4/13).
A
Fig.4/13
Push up on the handle once the tank is back to latch it to
the unit (Fig.4/14).
Fig.4/14
Check tank to make sure it is securely latched.
NOTE: There may be a small amount of water
(indicated by arrows - Fig.4/15) on the base when the
tank is removed from the unit. This is a normal
condition.
Fig.4/15
Recovery Tank (Lower Tank)
The recovery tank holds the dirty solution that is picked up
from the surface being cleaned.
When the recovery tank is full, the automatic shut-off will
engage, suction will stop (see page 6), and the tank must
be emptied.