Vauxhall VECTRA Owner's Manual page 47

42 Keys, doors, windows, sunroof
4. Press the button on the manual remote
control unit while pressing and holding
the desired button of the univ ersal
remote control.
5. The control indica tor in the mirror
housing will flash slowly at first. As soon
as it flashes rapidly , release b oth
buttons. The universal remote control
system is now programmed for the
chosen system .
6. To prog ra mme other buttons with other
system s, repeat steps 3 to 5.
If a sy stem cannot be operated after
rep eated programming, and the control
indicator flashes ra pidly for a short time
after the relevant button has been pressed
and then illuminates for 2 seconds, the
receiver may be equipped with a variable
code sy stem - see next column.
Prog ramm ing the universal remot e
control system for vari able code systems
1. Perform b asic prog ra mming –
see prev ious pag e.
2. Activate synchronisation m ode of
system (see system manufac turer's
opera ting manual) and briefly press the
pre-prog ra mmed button on the
universal remote control three times
within 30 sec onds.
3. The universal remote control system is
now programm ed for v ariable c od e
systems. To program me other sy stems
for variable codes, repeat steps 1 and 2
for the other buttons on the universal
rem ote control.
Usi ng t he universal remote control system
With the ignition on, press the required
universal remote control b utton and the
control indicator in the mirror housing will
illuminate. The pre-programm ed system
can now be operated using the universal
remote control system .
Reprog ramm ing indiv idual button
settings
If a button that has already b een
programm ed is to b e used for a different
system, repeat steps 3 to 5 of the ba sic
programm ing procedure described
previously.
C lea ring all progra mmed but ton sett ings
Before selling the vehicle, it is a good id ea
to erase button setting s.
Button setting s ca n only be erased all at
once. It is not possible to erase ind iv idual
button setting s. Buttons can, however, be
individually reprogrammed - see
"Reprogramming indiv idua l button
settings".
In order to erase the programm ing of all
3 buttons, press both outer buttons and
release a s soon as the LED begins to flash
(after approx. 20 seconds). All button
settings have now been clea red and can
be programm ed a new at any time.