Replacing Electronics And Display; 12 Recycling And Disposal; Appliance; Packaging - Vaillant ecoTEC plus Instructions For Installation And Servicing

11 Replacement parts

12 Recycling and disposal

13 Vaillant service

11.7

Replacing electronics and display

Danger!
Before replacing the component, comply with
the safety instructions in Section 11.1.
• Comply with the assembly and installation manuals
provided with the spare parts.
Replacing display or electronics
If you are replacing only one of the two components,
the parameter adjustment functions automatically.
On turning on the appliance, the new component
takes over the previously set parameters from the
components that are not replaced.
Replacing display and electronics
When replacing both components, after being turned
on, the appliance goes to fault and displays the error
message "F70".
• In the second diagnostic level, under the diagnostic
number "d.93" enter the number of appliance variant
according to Table 11.1 (see section 10.1.2).
The electronics is now set to the appliance type and
the parameters of all adjustable diagnostics numbers
correspond to the factory settings.
SPIGOT
BUNG
(remove
and discard)
Fig. 11.3 Condense trap
46
ADAPTER
FLOAT
CONDENSE
TRAP
SCREW
SPIGOT

Appliance

ecoTEC plus 415
ecoTEC plus 418
ecoTEC plus 428
ecoTEC plus 438
Table 11.1 Device specific numbers
12 Recycling and disposal
The design of all Vaillant products takes into account
the subsequent recycling and/or eventual safe
scrapping of each component used. Vaillant's in–house
rules set strict standards in this respect. The selection
process used for choosing raw materials includes
full consideration of their recycling characteristics,
and of the breakdown and separation properties of
sub assemblies. We also take fully into account the
environmental and health hazards involved in recycling
and in the disposal of non–reusable waste items.
12.1 Appliance
The Vaillant ecoTEC plus consists largely (92 %) of
metal components designed for eventual recycling
by incorporation into the smelting process of a
steelworks. This gives these parts virtually unlimited
scope for subsequent re-use. All plastic materials are
duly identified to facilitate sorting and separation
when the time comes to recycle the unit.
12.2

Packaging

Vaillant endeavours to keep the amount of transport
packaging used for its equipment to the bare minimum
necessary. Subsequent re–use is taken into account
when selecting packaging materials. High–quality
cardboard has long been a valuable secondary raw
material for the card and paper industry. The sections
of EPS (Styropor®) are required in order to protect
equipment in transit. EPS is 100 % recyclable and
CFC–free. The foil–wrapping and securing straps are
likewise made of recyclable plastic.
13 Vaillant service
To ensure regular servicing, it is strongly
recommended that arrangements are made for a
Maintenance Agreement. Please contact Vaillant
Service Solutions (0870 6060 777).
Device specific number
0
1
2
3
Installation and Servicing ecoTEC plus