Changing Bluetooth Code; Audio System; Infotainment System Controls; Voice Control - Buick Encore Owner's Manual

/ (Mute/End Call): Press to
end a call, reject a call, or to cancel
an operation.
To make outgoing calls using the
call list.
1. Press or / .
2. Highlight the phone number by
toggling the SRC switch up
or down.
3. Dial the highlighted number by
pressing or /

Infotainment System Controls

: Press to enter the Phone
main menu.
Voice Control (If Equipped)
The voice control system uses
commands to control the system
and dial phone numbers.
Noise: The system may not
recognize voice commands if there
is too much background noise.
When to Speak: A tone sounds to
indicate that the system is ready for
a voice command. Wait for the tone
and then speak.
How to Speak: Speak clearly in a
calm and natural voice.

Audio System

When using the UHP system, sound
comes through the vehicle's front
audio system speakers and
overrides the audio system. Use
.
the / VOL knob during a call to
change the volume level. The
adjusted volume level remains in
memory for later calls. The system
maintains a minimum volume level.
Turning Bluetooth On or Off
1. Press the CONFIG button.
2. Select Phone Menu.
3. Select Bluetooth Settings.
4. Select Bluetooth.
Infotainment System
5. Select Activation.
6. Select Yes or No.

Changing Bluetooth Code

The default Bluetooth code should
work with most mobile phones.
If you are having difficulty pairing
your mobile phone, you can change
the code at any time.
1. Press the CONFIG button.
2. Select Phone Menu.
3. Select Bluetooth Settings.
4. Select Bluetooth.
5. Select Change Bluetooth Code.
6. Enter a new four-digit code, then
select OK.
7-17