Dialpad Passthrough For Objects - Aastra CT9143i Release Note

5i series release 2.3

Table of Contents

IP Phone Release Notes 2.3

New Features in Release 2.3

Examples

The following are examples of using the "mix" and "disableIcon" execute commands with the

AastraIPPhoneExecute object. These commands apply to both the RTP and multicast RTP

XML commands (RTPTx, RTPRx, RTPMTx, RTPMRx).

•

Send mix unicast RTP stream (if there is existing voice call) to 10.30.100.20:21000. Mix

icon is displayed on the phone's call screen.

</AastraIPPhoneExecute>

•

Receive unicast RTP stream from 10.30.100.20 at port 21000 with the egress voice settings

at 3 levels more than the current offset and play on top of the existing voice stream (if any).

</AastraIPPhoneExecute>

•

Receive unicast RTP stream from 10.30.100.20 at port 21000 with the voice settings as used

earlier and play on top of the existing voice call (if any). Also, the mixing icon is not shown

on the call screen.

</AastraIPPhoneExecute>

Dialpad Passthrough for Objects

In previous releases, when an XML application was active on the phone, it suppressed all

dialpad events. This suppression was to prevent digit events from being sent to the underlying

line application.

On the IP Phones, an XML Developer can now control digit passthrough while the phone is in

the connected state. (This feature is only applicable to phones in the connected state). This can

be done by setting the new "allowDTMF" attribute with the XML objects

AastraIPPhoneTextScreen, AastraIPPhoneFormattedTextScreen, and

AastraIPPhoneImageScreen. Setting this attribute to "yes" allows dialpad events to pass

through the XML applications.

Note: The default behavior for this feature is to suppress dialpad events

when an XML object is in focus (same as in previous releases). Other

XML objects ignore this attribute.

RN-001029-02, Release 2.3, Rev 00

Table of Contents

9143i 9480i 9480i ct 55i 57i 57i ct ... Show all