Fault Codes - Frigidaire HEAVY DUTY AIR CONDITIONER Use & Care Manual

Air Conditioner Features
(Continued)
REMOTE SENSING FEATURE (on some models):
Note: This feature can be activated from the remote control
To activate the remote sensing feature, point the remote control towards the unit and press the remote sensing
start button.
The LIGHT on the unit control will pulse to indicate it received the signal. The LIGHT on the remote control will
pulse each time it sends a signal. It will continue to send this signal until the feature is deactivated by pressing
the remote sensing stop button. If the unit does not receive the remote sensing signal during any 3 minute
interval, the unit will keep to indicate the remote sensing mode has ended. The display on the remote control
indicates the temperature at the remote

FAULT CODES

TO TURN UNIT OFF:
Temp/Timer
Auto Clean
Temp Air
Cool
Temp/Timer
Energy Saver
Fan Only
Timer
Mode
LIGHT Pulsing
On & Off
Intermittently
DO THIS:
PRESS SENSING
START BUTTON
ONLY . The unit display indicates the set temperature.
Auto Clean
Temp
Cool
Energy Saver
Fan Only
Mode
If the display reads "AS", a sensor has
failed. Contact your Authorized
Frigidaire Service Center
Check
Sleep
Filter
Remote
Sensing
On
Off
Temp/Timer
Auto Clean
Temp Air
Cool
Temp/Timer
Energy Saver
Fan Only
Timer
Mode
Note: unit display shows
"Set" temperature
ONLY
Temp/Timer
Check
Sleep
Air Filter
Temp/Timer
Remote
Sensing
Timer
On
DO THIS:
PRESS ON/OFF
BUTTON
9
YOU WILL SEE:
Check
Sleep
Filter
Remote
Sensing
On
Off
Note: remote display is
actual temperature at
remote control only
.
Off
YOU WILL SEE:
Auto Clean
Temp Air
Cool
Energy Saver
Fan Only
Mode
Temp/Timer
Check
Sleep
Filter
Temp/Timer
Remote
Sensing
Timer
On
Off