Run Adaptiq Calibration - Bose CINEMATE 1 SR Setup Manual

S S
YSTEM ETUP
A. Point the remote at the speaker array and press the system power button.
B. Check that the power indicator on the speaker array is on (white), indicating the
system is on, and that the status indicator is off.
If the Status indicator is blinking orange:
• There is no wireless connection between the speaker array and the
Acoustimass
• See the Troubleshooting table in the back of the operating guide and
follow the instructions for correcting the problem of "No Sound."
C. Put the ADAPTiQ
the left and right sensors rest above your ears.
During the audio calibration the headset allows the
®
CineMate 1 SR system to hear exactly what you
hear.
D. Slide the ADAPTiQ connector cover off the end of the speaker array.
ADAPTiQ button
E. Insert the ADAPTiQ
fully seated.
The status indicator on the speaker array will glow green and the ADAPTiQ
calibration system will start automatically.
18 – English
Status
®
module.
® headset on your head making sure
ADAPTiQ headset connector
ADAPTiQ
ADAPTiQ connector cover
® headset cable into the ADAPTiQ headset connector until it is
Power
Sensor