Page 1
RIBBON USER GUIDE Read Me to Get the Most Out of Your Device...
Page 2
3.5mm audio input. The intuitive controls make controlling your music or making and taking calls a breeze. You can also use your Ribbon in your car or your home with the supplied cable.
Page 4
The Ribbon features an iPhone battery meter so you can check your battery status at a glance. Pair Your Phone or Bluetooth Streaming Device To get started you need to pair the Ribbon with your phone or device. 1. Hold down for about 3 seconds until the LED starts fl...
Page 5
3 seconds). 2. Hold down for about 5 seconds, until the LED starts fl ashing. The Ribbon will switch on and go straight to pairing mode, Follow the instructions above to pair your phone or Bluetooth streaming device. Note: When powered on, the Ribbon will try to connect to the last phone it was connected to.
Page 6
Using your Ribbon with a Hi-Fi, Speaker or Dock To use your Ribbon with your Hi-Fi simply plug one end of the supplied 3.5mm stereo adaptor cable into the Ribbon headphone socket and the other end into the AUX port or 3.5mm audio input on your Hi-Fi, speaker or dock.
Page 7
Using your Ribbon in the Car To use your Ribbon in the car simply plug one end of the supplied 3.5mm stereo adaptor cable into the Ribbon headphone socket and the other end into the AUX port in your car. Then set your car stereo to use AUX input.
Page 8
3mm. Tip: There are separate volume controls for the Ribbon and your phone. For best results please ensure your phone is set to at least half volume. You can then use the Ribbon to control the volume.
Play / Pause Click Skip forward Hold for 2 seconds Skip back Hold for 2 seconds Increase volume Click Reduce volume Click Note: If you continue holding the + or - buttons, the Ribbon skips through one track every 2 seconds.
Page 10
Using your Ribbon for Phone Calls The Ribbon is also equipped with a microphone to allow you to make and receive phone calls. For best results please ensure the Ribbon is worn as close to the mouth as practical. Function...
LED is solid white (red if the battery charge is low) Power Off Hold down for about 3 seconds, until the LED fl ashes red Note: The Ribbon will switch off automatically after 5 minutes if there is no phone or music source connected.
Specifi cations Bluetooth 3.0 Charge time: 1 - 2 hours Standby time: Up to 250 hours Music play time: Up to 6 hours The Ribbon features aptX for full ‘wired’ audio quality over Bluetooth on aptX enabled phones.
Reads your incoming text messages > Helps with pairing and setup Go to the Android Market and search for “BlueAnt” to download and install this free application. Once the application is installed you will hear your text messages read aloud automatically on your BlueAnt device as they come in.
Please contact us before returning the Ribbon to a store and we will help you through any diffi culty you may have. Terms and Conditions By using this product, you are agreeing to BlueAnt’s terms and conditions, available at www.blueantwireless.com...
Page 15
BlueAnt and other trademarks are trademarks of BlueAnt and other organizations and may not be used without permission. The BlueAnt logo is registered in the U.S. Patent and Trademark Offi ce and globally with the World Intellectual Property Organization under the Madrid protocol.